FAQ Search Select a Category Cleaning Formulas Cleaning Tips Corporate Deep Cleaners FAQ Hard Floor Cleaners Parts and Accessories Steam Sweepers Vacuums Warranty Web Site and/or go How do I remove and replace the latch on my CleanAlong® ? Answer: Using a flat head screwdriver, gently wedge the tip of the screwdriver along the side of the old latch. Push inwards with the screwdriver to pop the latch out of its hole on one side. Remove the old latch and discard. With the new latch, gently line-up one side of the latch in the corresponding hole on the unit. Make sure the spring in the center of the latch is also lined up. Use the flathead screwdriver to gently push remaining side into remaining hole on the unit. Move latch back & forth to confirm it moves freely & springs back into place. Confirm the door of the unit will lock close. Latch installation is now complete. Related Questions How can I clear clogs in my Lift-Off® Vacuum? My CleanView® has low to no suction. What should I do? My AeroSwift™ Vacuum is blowing dust. What can I do? Where can I buy bags, belts, and filters for the BISSELL ProLite?