FAQ Search Select a Category Cleaning Formulas Cleaning Tips Corporate Deep Cleaners FAQ Hard Floor Cleaners Parts and Accessories Steam Sweepers Vacuums Warranty Web Site and/or go My machine will spray through the hose attachments but not through the floor. How do I resolve this? Answer: Please check the following to try to resolve the problem: Squeeze and release the trigger to see if it springs back. If yes, the unit may have lost prime. To prime hold the trigger in for 30 seconds with the unit turned off. Remove flow indicator cap and check to see if water comes through the flow indicator when the trigger is depressed. If there is no tension in the trigger, check the square valve on the unit by removing the upper handle and manually depressing it to see if water comes through the flow indicator with the cap off. (This will not apply to Self Propelled units). Inspect handle to see if the push rod is moving in relationship to the trigger. If not, you will need a handle replacement. If yes, reinstall the handle and try again. If the square valve is not in place, please contact an Authorized Service Center for additional assistance. Does water come through the flow indicator? If no, please contact an Authorized Service Center for additional assistance. If yes, pour hot tap water (½ - 1 cup) into the flow indicator. Let the unit sit for about 30 seconds then check to see if water came out through the floor. If yes, put the flow indicator cap back on and check for spray. If no water came through to the floor, check for debris on the spray tips (red or white) located behind the brush roll underneath the machine. Clean with soft brush (an old toothbrush works great). Then put vinegar and water into the flow indicator and let sit for about 30 minutes. (Be sure to place a towel under the machine or make sure the machine is on a surface that would not be damaged by water.) If these suggestions have not resolved the problem you are experiencing with your machine, please contact BISSELL Consumer Services at 1-800-263-2535, Monday - Friday 8 a.m. to 10 p.m., or Saturday 9 a.m. to 8 p.m., ET or email us by clicking on the Email BISSELL tab at the top of this page. Related Questions Why did the brush stop rotating on my machine? What are the main uses for the Acarosan spray? I have an upright carpet cleaner. When mixing the cleansing formula do I use it full strength or dilute it in my machine? Can I use OxyPRO as a pretreater to deep cleaning?