Shopping Cart
Exclusive Offer for Email Subscribers! Learn More
Get free shipping on any order over $40!Learn More
  • Pay with PayPal Fast & Easy Checkout
  • FREE Shippng FREE Shipping over $49
  • ribbon 30-Day Returns
  • COVID-19 Update
  • Pay with PayPal
  • FREE Shippng
Why shop at
  • ribbon

My Rewind TurboBrush is not turning. What should I do?


1. Let’s start by turning off the vacuum. Remove the TurboBrush® from the hose and then turn the vacuum back on, checking for suction at the end of the hose. If there is suction at the end of the hose, go on to step 3. If there’s no suction at the end of the hose, go on to step 2.

2. If there’s no suction at the hose, check the hole within the dirt container locking lever (found just below the dirt container and the filter, pictured below). There should be a circular, black filter inside this hole. Check for suction without removing it. If there’s suction here, likely the hose is clogged or the filters are dirty. To unclog, detach the hose from the vacuum and insert a broomstick into the hose to push any obstruction through to the opposite end. Please note: a coat hanger is not recommended to clear a clog, as it may damage the hose. If after cleaning the filters and/or unclogging the hose the TurboBrush still won’t turn, go on to step 3. If there’s no suction at this spot, please see our FAQ on low or no suction.

18M9 dirt container 2

3. Using a Phillips-head screwdriver, remove the back-side of the TurboBrush, pictured below.

18M9 turbobrush

4. Next, remove the belt guard screw (pictured below) using Phillips-head screwdriver.

18M9 turbobrush belt guard

5. Remove the belt and brush and remove any attached hair or debris. If the belt is broken, you’ll need to replace the TurboBrush. You can do so here:

18M9 turbobrush 2

6. Next, pull off ends of the brush caps and remove any debris or hair.

18M9 turbobrush caps

7. Now, remove the suction-wheel by sliding upward. Clean the debris and replace by sliding downward into the slots.

18M9 turbobrush wheel

8. Reassemble the brush-ends, loop the belt over the brush-gear, slide the brush into place, and secure the belt guard in place. (Pictured below.)

18M9 turbobrush reassemble

9. Reattach the cover.

18M9 turbobrush cover

10. If the TurboBrush still won’t turn, you’ll need to replace it. You can do so by clicking here:

Show fewer features
Show more features
Show All Specs
Hide All Specs