Check out our easy tips to get your machine to spray again.
Of course; always start with a full tank of water.
-The hose solution line much be connected properly. Check the connection at the front of machine. Firmly insert and twist to the right.
-The wet button must be pressed in also
-Make sure the water tank is seated down properly in the tank. The red colored gasket must be on properly as well as the insert. Check out the photos.
- Is the X-valve dispensing solution? Press while over a sink to see if water comes out.
-There are 2 small o-rings on the fitted end of the Hose Solution line; make sure they are there yet.
-By running the unit for 5 minutes with all three buttons powered on. This should dislodge any clogs in the heater.
If there is still no spray; it would be best to contact a BISSELL Authorized Service Center at this link: