Upper Tank Filter
Pre-Motor Filter
Post-Motor Filter

We recommend that you check and clean the Upper Tank and Pre-Motor Filters in your vacuum about once a month. The Post-Motor Filter should be cleaned or replaced about every three months. It only takes a couple of minutes to remove the filters from your machine and clean them. Simply brush the dirt off and hand wash under running water. Be sure they are completely dry before you put them back in your vacuum.

By signing up here, you will receive a monthly email,
reminding you of this important maintenance!

Note: Select models come with a white, pleated HEPA Media Post-Motor Filter.
This filter is NOT washable and must be replaced.

Click here for complete instructions on cleaning filters.

 

 

 

Use only BISSELL Replacement Filters in your BISSELL CleanView.

Upper Tank Filter: 203-1085

  1. Unplug the cleaner from electrical outlet.
  2. The Upper Tank Filter can be reached by removing the Dirt Container, reaching underneath the Upper Tank and turning the rim of the Filter Frame to unlock. Pull straight down to remove. Brush the dirt off the Louvers and Upper Tank Filter.

    Note: When you remove the Filter Frame, a POST will drop. This is to prevent accidentally replacing the Dirt Container without the Upper Tank Filter and Frame in place.

  3. The foam Upper Tank Filter may be removed and hand washed in cold water with mild detergent. Rinse well then air dry thoroughly before replacing.

  4. The Upper Tank and Louvers may be wiped clean with a damp cloth.

    Note: For easier access, the entire Upper Tank may be removed by turning the knob on the back of the cleaner to unlock and pulling the entire tank straight out.

 

 



 

Use only BISSELL Replacement Filters
in your BISSELL CleanView:
Pre-Motor Filter 203-1073
Post-Motor Filter 203-1009
HEPA Media Post-Motor Filter 32076 (Select Models Only)
  1. Unplug the cleaner from the electrical outlet.

  2. The Pre-Motor Filter protects the motor from dirt particles. It is located in the slide out tray underneath the Dirt Container. If the filter becomes dirty, pull out the tray, lift out the filter, and clean.

  3. The Post-Motor Filter assists in the filtration process to return clean air to the room. It is located behind the door on the side of the cleaner. If the filter becomes dirty, open the door, remove the filter, and clean.

    NOTE: Select Models come with a white, pleated HEPA Media Filter. This filter is not washable and must be replaced.


  4. The standard filters may be hand washed in cold water with mild detergent. Rinse well and air dry thoroughly before replacing.